Dark Brown Leather Sofa With Wood Floor?

Tabletop --- do it yourself

this week we have built a tabletop itself. The idea came from various contributions from the Internet.

The required equipment we had except the white board, all buried in the cellar. The wood tick
is for ages old and used, but this is not bad.

is Used:

a simple wooden block from the hardware store with hinges Height: 75cm, width 75cm

2 edge rails Tiles, length 70cm

2 wooden slats (width 3-5cm) à 70cm

some wood screws

1 PVC foam board, 50x125cm 3mm

on the folding block must be the side hinges unscrew the legs and screw on top so again that the goat can be opened at a 45 degree angle.

The wooden bar is bolted together with aluminum rail on one foot, whilst allowing the aluminum rail to withstand anything the PVC plate then insert it.

to get

a measure of the other side, the PVC should be screwed into the plate and just stuck profile CAREFULLY bend until you get a flat surface. It depends on the length of the plate.

The second rail in place with the wood lath, insert the disk and off you go with the Fototgrafieren.

The beautiful, the plate can take out, fold the wooden support and stowed away or transported.

The tabletop I have already tested, it is a cool Thing. What's missing is a wooden top bar where you can even attach a flash. Since we'll have to think of something. Otherwise it is a low cost alternative to the tabletops can buy it, especially if you do not ever need.

costs were, all in all, about 30 € or just see what even the standing around in the basement ;-)